Calibration problems – Zebra Technologies Z6Mplus User Manual
Page 110

92
Z4Mplus/Z6Mplus User Guide
13163L Rev. 3 5/20/2004
Troubleshooting
Calibration Problems
Calibration Problems
Table 14 • Calibration Problems and Solutions
Problem
Recommended Solution
Loss of printing registration on
labels.Excessive vertical drift in top-of-form
registration.
Ensure that the media guides are properly positioned.
Set the printer for the correct media type. See
.
Adjust the reflective sensor position. See
Via the front panel, locate the SENSOR SELECT menu item
(see
) and manually select the
correct sensing method.
Reload the media. Check the reflective sensor position (see
Adjust the Reflective Sensor on page 84
Clean the platen roller according to the instructions in
the Printhead and Platen Roller on page 77
.
Auto Calibrate failed.
Perform a manual calibration (see
Calibration (Manual Calibration) on page 63
).
Reload the media and ensure that the reflective sensor is
properly positioned (see
).