beautypg.com

Exit configuration mode – Zebra Technologies Z6Mplus User Manual

Page 69

background image

Configuration

Overview

13163L Rev. 3 5/20/2004

Z4Mplus/Z6Mplus User Guide

51

Exit Configuration Mode

You can leave configuration mode at any time.

To exit configuration mode, complete these steps:

1.

From the front panel, press SETUP/EXIT.
The

SAVE CHANGES

display appears.

2.

Press PLUS (+) or MINUS () to scroll through the choices (

Table 8

):

3.

Press SELECT to select the displayed choice.

4.

Press SETUP/EXIT to save your choice.

Table 8 • Save Options When Leaving Setup Mode

LCD Display

Description

PERMANENT

Permanently saves the changes. Values are stored in the printer even when power
is turned off.

TEMPORARY

Saves the changes until you change them again or until power is turned off.

CANCEL

Cancels all changes from the time you pressed

SETUP/EXIT

except the

darkness and tear-off settings (if they were changed).

LOAD DEFAULTS

Sets all parameters other than the network settings back to the factory defaults.
To see the factory default values, see

Configuration and Calibration LCD

Displays on page 57

.

Note •

Loading factory defaults causes the printer to auto-calibrate.

LOAD LAST SAVE

Loads values from the last permanent save.

DEFAULT NET

Sets the wired and wireless network settings back to factory defaults.