Zebra Technologies Z6Mplus - Manual (Page 114)

96 Z4Mplus/Z6Mplus User Guide 13163L Rev. 3 5/20/2004
Troubleshooting
Printer Diagnostics
CANCEL Self Test
This self test prints a listing of the configuration parameters currently stored in the printer’s
memory. See
Figure 40 . Depending on the options ordered, your label may look different.
Figure 40 • Sample Configuration Labels
The configuration shown on the label may be changed either temporarily (for specific label
formats or ribbon and label stock) or permanently (by saving the new parameters in memory).
See
Basic Configuration on page 53 for further information about the configuration procedure.
To perform the CANCEL Self Test, complete these steps:
1. Turn the printer Off ( O ).
2. Press and hold CANCEL while turning On ( l ) the printer.
3. Release CANCEL after the DATA light turns off (approximately five seconds).