Xantrex Technology PROsine 2.0 - Manual (Page 96)

Operation
5–10 445-0089-01-01
Part 5: Display Mode Screens
When the DISPLAY switch is ON, you can view the screens shown below. (The
values shown here are examples only.) Display Mode screens are updated
continuously to show current PROsine operating data. You can scroll through
them by pressing the Up s
and Down t MENU buttons.
Screen 1
Screen 2
Screen 3
Screen 4
Important: In the screens below current polarity is indicated as follows:
+ indicates current going into the battery (i.e. + indicates charging).
– indicates current coming out of the battery (i.e. – indicates that the battery is supplying
loads or the
PROsine is inverting).
OR
Shows the PROsine’s voltage and current readings from the battery as well as the
battery temperature. If the battery temperature sensor is not installed, the screen on the
right is displayed.
PROsine: Battery
12.0V +10A 22 ° C
PROsine: Battery
12.0V +10A
Shows the voltage, current, and frequency of the shorepower (i.e. input AC).
PROsine: AC In
118.0V 5A 58Hz
Shows the voltage, current, and frequency of the output AC.
PROsine: AC Out
120.0V 10A 60Hz
OR
Combines the battery display (Screen 1) with the AC output display (Screen 3).
The left-hand screen appears if the battery temperature sensor is installed. Output AC is
shown on the bottom. The PROsine’s voltage and current readings from the battery as
well as the battery temperature appear on top.
The bottom of the right-hand screen shows the output AC. The top shows battery
voltage and current as read by the PROsine. (This is the screen that appears if the battery
temperature sensor is not installed.)
12.0V –120A 22 ° C
120V 10A 60Hz 120V 10A 60Hz
12.0V –120A