Xantrex Technology PROsine 2.0 - Manual (Page 56)

Installation
3–14 445-0089-01-01
The PROsine is shipped with the screw in the position that enables the automatic
bonding system.
• To disable the system, move the screw to the other hole.
• Do not remove the screw from the product: make sure it is always installed in
one position or the other, as appropriate for the configuration of the rest of the
system.
Table 3-4 AC Output Neutral-to-Ground Bonding Screw Settings
Bonding Screw
Setting Status of Bonding
Internal to the PROsine Neutral Bonding Required
External to the PROsine
AC shorepower not
present (unit Inverting
or in Standby) AC shorepower present
(unit Charging or in
Standby) In the AC input
shorepower
source In the AC load
panel
Automatic
bonding Output neutral bonded Output neutral
un-bonded Yes No
Un-bonded in
all modes Output neutral un-
bonded Output neutral un-
bonded No Yes