Xerox 16 Series - Manual (Page 81)

Error Messages 3-11
3
Jam Punch Sensor 1. There is a sheet of
paper blocking the
Punch Sensor
(fourth sensor from
the left).
2. The Punch Sensor
and/or its Reflector
may be dirty.
3. The Side Guide may
be adjusted too tight
for the paper, cover
stock, or tab stock.
1. Lift up the Sheet Eject
Strap assembly and
remove the paper.
2. Clean the Punch Sensor
and reflector, using
Isopropyl alcohol and a
clean, lint-free cloth.
3. Ensure that the Side Guide
is not too tight. Perform
the adjustment in Chapter
2 (Setting the Side Guide).
If the problem persists, call
your GBC or Xerox
Service Representative.
4. Press Stop/Reset
button to clear error
message. Follow printer
jam clearance procedure
and resume the job.
Jam Punch Exit Sensor 1. There is a sheet of
paper blocking the
Punch Exit Sensor at
the Stacker’s input.
2. The Punch Exit
Sensor and/or its
Reflector may be
dirty.
1. Lift up the Stacker Top
Cover and remove the
paper.
2. Clean the Punch Exit
Sensor and reflector, using
Isopropyl alcohol and a
clean, lint-free cloth. If the
problem persists, call your
GBC or Xerox Service
Representative.
3. Press Stop/Reset
button to clear error
message. Follow printer
jam clearance procedure
and resume the job.
Error Message Possible Cause Resolution
Figure 3-4: Punch-Generated Error Messages