Xerox 16 Series - Manual (Page 113)

Personality Profiles A-19
A
DocuTech 6155/6180 to FusionPunch II to
SBM 2 –w ithout CIM
Device Profile - Properties and Default Limits –
Timings Tab
(*) = For Each High Capacity Stacker on a DT6155 / 6180, Add 656ms To Sheet
and Set Jam Times.
(#) = For Each High Capacity Stacker Add 50ms To End of Set Offset.
Paper Sizes
Set Sizes
Non-Stream Feed /
Stream feed
8.5x11/8.5x14/A4
1 to 22 Sheet Set
Non-Stream Feed
8.5x11/8.5x14/A4
1 to 22 Sheet Set
Stream Feed
8.5x11/8.5x14/A4
23 to 27 Sheet Set
Non-Stream Feed
Tim e Between Sheets 120 120 120
Sheet Jam Time (*) 800 (*) 800 (*) 800 (*)
Set Compiler
Processing Time
150 150 400
Maxim um Set
Processing Tim e
1200 1800 0
Set Jam Time (*) 7168 (*) 7168 (*) 7168 (*)
Tim e to Cycle Up 0 0 0
S0 Enabled Enabled Enabled
S1 Enabled Enabled Enabled
S2 Enabled Enabled Enabled
S3 Disabled Disabled Disabled
S4 Disabled Disabled Disabled
Delivery Signal Type Lead Edge Lead Edge Lead Edge
Delivery Start Adjust 0 0 0
Delivery End Adjust 50 50 50
End of Set Offset (#) 20 20 20
Recovery Behavior SET SET SET
Finisher Capacity 7 7 7
Cycle Down Delay 0 0 0