Toshiba Libretto U100 - Manual (Page 144)

7-4 User’s Manual
HW Setup
3. Use the left/right cursor keys to highlight the boot device you want and
press Enter.
Network Boot Protocol
This feature sets the protocol to remotely boot from the network.
[PXE]
Sets PXE as the protocol (Default).
[RPL]
Sets RPL as the protocol.
HDD Priority Options
Set the priority when the hard disk drive is used as the startup device.
■ If only a Supervisor Password has been set, the following should be
noted:
■ The boot device menu will appear when you use the user password
to start the computer and the ‘Able to run HW Setup’ option has
been configured.
■ The boot device menu will not appear when you use the user
password to start the computer and the ‘Unable to run HW Setup’
option has been configured.
■ If both a Supervisor Password and a User Password are set, the
following should be noted:
■ The boot device menu will appear when you use either the
Supervisor Password or the User Password to start the computer,
and the ‘Able to run HW Setup’ option has been configured.
■ The boot device menu will not appear when you use the User
Password to start the computer and the ‘Unable to run HW Setup’
option has been configured.
■ The boot device menu will appear when you use the Supervisor
Password to start the computer, even if the ‘Unable to run HW
Setup’ option has been configured.
■ The boot device selection methods described above will not change
the boot priority settings that have been configured in HW Setup. In
addition, if you press a key other than one of those listed, or if the
selected device is not installed, the system will continue to boot
according to the current and available settings in HW Setup.
Built-in HDD ->
USB (Default)
The priority is set as built-in HDD -> USB
memory.
USB -> Built-in
HDD
The priority is set as USB memory -> built-in
HDD.