Wasp Bar Code Wasp Duraline WLS 8400 FZ - Manual (Page 94)

WLS 8400 Product Reference Guide 6-6
RS-232 Host Parameters
Various RS-232 host types are set up with their own parameter default settings. Selecting
the host type sets the parameter defaults as listed in
Table 6-2 .
Table 6-2. Terminal Specific RS-232
Parameter
Standard
RS-232
(Default) ICL
Wincor-
Nixdorf
Mode A
Wincor-
Nixdorf
Mode B
Olivetti Omron
OPOS/
JPOS Fujitsu
Transmit
Code ID No Yes Yes Yes Yes Yes Yes Yes
Data
Transmission
Format Data as is Data/
Suffix Data/
Suffix Data/
Suffix Prefix/
Data/
Suffix Data/
Suffix Data/
Suffix Data/
Suffix
Suffix
CR/LF
(7013) CR (1013) CR (1013) CR (1013) ETX
(1002)
CR (1013) CR (1013) CR (1013)
Baud Rate 9600 9600 9600 9600 9600 9600 9600 9600
Parity None Even Odd Odd Even None Odd None
Hardware
Hand-
shaking None RTS/CTS
Option 3 RTS/CTS
Option 3 RTS/CTS
Option 3 None None RTS/CTS
Option 3 None
Software
Hand-
shaking None None None None Ack/Nak None None None
Serial
Response
Time-out 2 Sec. 9.9 Sec. 30.0 Sec. 30.0 Sec. 9.9 Sec. 9.9 Sec. 30.0 Sec. 2 Sec.
Stop Bit
Select One One One One One One One One
ASCII
Format 8-Bit 8-Bit 8-Bit 8-Bit 7-Bit 8-Bit 8-Bit 8-Bit
Beep On
Disable Disable Disable Disable Disable Disable Disable Disable
RTS Line
State
Low High Low Low = No
data to
send Low High Low = No
data to
send Low
Prefix
None None None None STX
(1003) None None None