Wasp Bar Code Wasp Duraline WLS 8400 FZ - Manual (Page 178)

WLS 8400 Product Reference Guide 8-32
Code 93
Enable/Disable Code 93
To enable or disable Code 93, scan the appropriate bar code below.
Enable Code 93
*
Disable Code 93
Set Lengths for Code 93
The length of a code refers to the number of characters (i.e., human readable characters),
including check digit(s) the code contains. Lengths for Code 93 may be set for any length,
one or two discrete lengths, or lengths within a specific range.
One Discrete Length - This option allows scanner to decode only those Code 93 symbols
containing a selected length. Lengths are selected from the numeric bar codes beginning on
page
D-1 in Chapter D, Numeric Bar Codes . For example, to decode only Code 93 symbols
with 14 characters, scan Code 93 - One Discrete Length, then scan 1 followed by 4. In
case of an error, or to change the selection, scan Cancel on page
D-7 .
Code 93 - One Discrete Length