Wasp Bar Code Wasp Duraline WLS 8400 FZ - Manual (Page 26)

WLS 8400 Product Reference Guide 1-6
4. Close the clamp, push it back into place and tighten the screws on the clamp to
secure the cable into the bottom of the scanner.
5. Connect the other end of the interface cable to the host (see the specific host chapter
for information on host connections).
Different cables are required for different hosts. The connectors
illustrated in each host chapter are examples only. The connectors
may be different than those illustrated, but the steps to connect the
scanner remain the same.
Connecting Power (if required)
If the host does not provide power to the scanner, an external power connection is required
to power the scanner. To connect power:
1. Connect the interface cable to the bottom of the scanner, as described in Installing
the Interface Cable on page 1-5 .
2. Connect the other end of the interface cable to the host (refer to the host manual to
locate the correct port).
3. Plug the power supply into the power jack on the interface cable. Plug the other end
of the power supply into an AC outlet.