Wasp Bar Code Wasp Duraline WLS 8400 FZ - Manual (Page 344)

WLS 8400 Product Reference Guide A-4
Convert Wedge Data Do Not Convert Wedge
Data 5-14
Function Key Mapping Disable 5-14
FN1 Substitution Disable 5-15
Send Make and Break Send Make and Break
Scan Codes 5-15
RS-232 Host Parameters
RS-232 Host Types Standard RS-232
1
6-9
Baud Rate 9600 6-10
Parity None 6-12
Check Receive Errors Enable 6-13
Stop Bit Select 1 Stop Bit 6-14
Data Bits 8-Bit 6-14
Hardware Handshaking None 6-15
Software Handshaking None 6-18
Host Serial Response Time-out Minimum: 2 Sec 6-20
RTS Line State Host: Low RTS 6-21
Beep on Disable 6-22
Intercharacter Delay Minimum: 0 msec 6-23
Nixdorf Mode A/B and OPOS/JPOS Beep/LED Options Normal Operation 6-24
Ignore Unknown Characters Send Bar Code 6-25
Table A-1. Standard Default Parameters Table (Continued)
Parameter Default Page Number
1
User selection is required to configure this interface and this is the most common selection.