Wasp Bar Code Wasp Duraline WLS 8400 FZ - Manual (Page 56)

WLS 8400 Product Reference Guide 4-8
Beep After Good Decode
Scan a bar code below to select whether or not the scanner beeps after a good decode. If Do
Not Beep After Good Decode is selected, the beeper still operates during parameter menu
scanning and indicates error conditions.
*
Beep After Good Decode
(Enable)
Do Not Beep After Good Decode
(Disable)
Trigger Mode
The scanner has three trigger modes that can be used to scan bar codes. The desired trigger
mode can be set by using the bar codes below.
Level Trigger
When the trigger is pulled, an aiming dot appears for a programmable duration of time.
After this time, the aiming dot automatically turns into a standard laser scanning beam for
a full decode session. The laser scanning beam stays on until the laser-on timeout occurs, a
decode occurs, or the trigger is released. If the trigger is released before the aiming duration
expires, the laser shuts off and no decode occurs.
*Level