Wasp Bar Code Wasp Duraline WLS 8400 FZ - Manual (Page 347)

Standard Default Parameters A-7
Transmit Code 39 Check Digit Disable 8-30
Code 39 Full ASCII Conversion Disable 8-31
Code 93
Code 93 Disable 8-32
Set Lengths for Code 93 4 to 55 8-32
Code 11
Code 11 Disable 8-34
Set Lengths for Code 11 4 to 41 8-34
Code 11 Check Digit Verification One Check Digit 8-36
Transmit Code 11 Check Digits Disable 8-37
Interleaved 2 of 5 (I 2 of 5)
Interleaved 2 of 5 (I 2 of 5) Enable 8-38
Set Lengths for Interleaved 2 of 5 14 8-38
I 2 of 5 Check Digit Verification Disable 8-41
Transmit I 2 of 5 Check Digit Disable 8-42
Convert I 2 of 5 to EAN-13 Disable 8-42
Discrete 2 of 5 (D 2 of 5)
Discrete 2 of 5 Disable 8-44
Set Lengths for D 2 of 5 12 8-44
Table A-1. Standard Default Parameters Table (Continued)
Parameter Default Page Number
1
User selection is required to configure this interface and this is the most common selection.