Wasp Bar Code Wasp Duraline WLS 8400 FZ - Manual (Page 180)

WLS 8400 Product Reference Guide 8-34
Code 11
Code 11
To enable or disable Code 11, scan the appropriate bar code below.
Enable Code 11
*
Disable Code 11
Set Lengths for Code 11
The length of a code refers to the number of characters (i.e., human readable characters),
including check digit(s) the code contains. Lengths for Code 11 may be set for any length,
one or two discrete lengths, or lengths within a specific range.
One Discrete Length - This option allows the scanner to decode only those Code 11
symbols containing a selected length. Lengths are selected from the numeric bar codes
beginning on page
D-1 in Chapter D, Numeric Bar Codes . For example, to decode only
Code 11 symbols with 14 characters, scan Code 11 - One Discrete Length, then scan 1
followed by 4. In case of an error, or to change the selection, scan Cancel on page
D-7 .
Code 11 - One Discrete Length