Wasp Bar Code Wasp Duraline WLS 8400 FZ - Manual (Page 34)

WLS 8400 Product Reference Guide 2-6
Scanning in Hand-Held Mode
Install and program the scanner (see Setting Up the Scanner on page 1-5). For assistance,
contact the local supplier or
Wasp Support .
1. Ensure the scanner is properly connected to the host (see the appropriate host
chapter).
2. Aim the scanner at the bar code.
3. Press the scan trigger.
Figure 2-2. Scanning in Hand-Held Mode
4. Ensure the scan line crosses every bar and space of the symbol.
5. Upon successful decode, the scanner beeps, and the LED turns green. For more
information on beeper and LED definitions, see Table 2-1 and Table 2-2 .
RIGHT
012345
WRONG
012345