Set lengths for codabar, Set lengths for codabar -47 – Wasp Bar Code Wasp Duraline WLS 8400 FZ User Manual
Page 193
Symbologies
8-47
Set Lengths for Codabar
The length of a code refers to the number of characters (i.e., human readable characters),
including check digit(s) the code contains. Lengths for Codabar may be set for any length,
one or two discrete lengths, or lengths within a specific range.
One Discrete Length - This option allows the scanner to decode only those Codabar
symbols containing a selected length. Lengths are selected from the numeric bar codes
beginning on page
in
. For example, to decode only
Codabar symbols with 14 characters, scan Codabar - One Discrete Length, then scan 1
followed by 4. In case of an error, or to change the selection, scan Cancel on page
Codabar - One Discrete Length
Two Discrete Lengths - This option allows the scanner to decode only those Codabar
symbols containing either of two selected lengths. Lengths are selected from the numeric
bar codes beginning on page
. For example, to
decode only those Codabar symbols containing either 2 or 14 characters, select Codabar -
Two Discrete Lengths, then scan 0, 2, 1, and then 4. In case of an error, or to change
the selection, scan Cancel on page
.
Codabar - Two Discrete Lengths