Wasp Bar Code Wasp Duraline WLS 8400 FZ - Manual (Page 161)

Symbologies 8-15
UPC/EAN/JAN Supplemental Redundancy
With Autodiscriminate UPC/EAN/JAN Supplementals selected, this option adjusts the
number of times a symbol without supplementals is decoded before transmission. The
range is from two to thirty times. 14 or above is recommended when decoding a mix of
UPC/EAN symbols with and without supplementals, and the autodiscriminate option is
selected. The default is set at 14.
Scan the bar code below to set a decode redundancy value. Next, scan two numeric bar
codes beginning on page
D-3 in Chapter D, Numeric Bar Codes . Single digit numbers must
have a leading zero. In case of an error, or to change the selection, scan Cancel on page D-7 .
UPC/EAN/JAN Supplemental Redundancy
Transmit UPC-A/UPC-E/UPC-E1 Check Digit
The check digit is the last character of the symbol used to verify the integrity of the data.
Scan the appropriate bar code below to transmit the bar code data with or without the UPC-
A, UPC-E or UPC-E1 check digit. It is always verified to guarantee the integrity of the data.
UPC-A Check Digit
*
Transmit UPC-A Check Digit
Do Not Transmit UPC-A Check Digit