Wasp Bar Code Wasp Duraline WLS 8400 FZ - Manual (Page 248)

WLS 8400 Product Reference Guide 10-32
Setup Field(s)
Table 10-1. Setup Field(s) Definitions
Parameter Description Page
Move Cursor
Move Cursor To a Character Scan the Move Cursor To Character bar code on page
10-33 , then any printable ASCII character from the
Alphanumeric Keyboard . When this is used, the
cursor moves to the position after the matching
character. If the character is not there, the rule fails
and ADF tries the next rule.
10-33
Move Cursor to Start of Data Scan this bar code to move cursor to the beginning of the
data. 10-33
Move Cursor Past a Character This parameter moves the cursor past all sequential
occurrences of a selected character. For example, if the
selected character is ‘A’, then the cursor moves past ‘A’,
‘AA’, ‘AAA’, etc. Scan the Move Cursor Past Character
bar code on page 10-33, then select a character from the
Alphanumeric Keyboard . If the character is not there, the
cursor does not move (i.e., has no effect).
10-33
Skip Ahead “N” Characters Scan one of these bar codes to select the desired number of
positions to move the cursor ahead. 10-34
Skip Back “N” Characters Scan one of these bar codes to select the desired number of
positions to move the cursor back. 10-36
Send Preset Value Send prefix and/or suffix value by scanning the appropriate
bar code. These values must be set using the Scan Prefix
and Scan Suffix bar codes on
page 9-6 .
10-38