Disabling single static ip – Westell Technologies Wirespeed 2100 User Manual
Page 61
030-300198 Rev. D
59
March 2003
WireSpeed Dual Connect NAT Router
User Guide
Disabling Single Static IP
The following screen displays that Single Static IP is enabled for device you selected. Click on disable if you want
to disable the Single Static IP for this device.
STOP! After you enable Single Static IP, you must reboot your computer and establish your PPP session.
If you clicked on disable in the preceding screen, the following pop-up screen will be displayed. Click on OK.
If you clicked on OK in the Disable IP Passthrough? screen, the following pop-up screen will be displayed. Click
on OK. This will allow the modem to be reset, and the new configuration will take affect.