Westell Technologies Wirespeed 2100 - Manual (Page 58)

030-300198 Rev. D 56 March 2003
WireSpeed Dual Connect NAT Router User Guide
If you clicked on OK in the preceding screen, the following screen will be displayed. This screen shows that the
Router is being reset.
Single Static IP Configuration
The following settings will be displayed if you select Single Static IP Configuration from the Configuration
menu. See the screens in the following sections.
STOP: Static NAT must be disabled before you can enable Single Static IP. To disable Static NAT, select Service
Configuration from the Configuration menu. Next, click on the static NAT button. Select the device from the
Static NAT Device pull-down menu and click on disable. Return to Single Static IP Configuration by selecting
Single Static IP Configuration from the Configuration menu.
Enabling Single Static IP
To enable Single Static IP, select the device that will share your Single Static IP address from the screen below.
Click on enable.
NOTE: The Single Static IP Configuration screen allows you to select a device on your LAN that will share your
Single Static IP address.