Westell Technologies Wirespeed 2100 - Manual (Page 51)

030-300198 Rev. D 49 March 2003
WireSpeed Dual Connect NAT Router User Guide
DHCP Lease Time Factory Default = 01:00:00:00
Displays the amount of time the provided addresses will be valid, after which
the DHCP client will usually re-submit a request.
NOTE: DHCP Lease Time is displayed in the format (dd:hh:mm:ss)*. (This
value must be greater than 10 seconds.) The default = 01:00:00:00. Seconds
must be between 0 and 59, minutes must be between 0 and 59, and hours must
be between 0 and 23.
*(dd = days, hh = hours, mm = minutes, ss = seconds)
Disabling the DHCP Server
If you click on the pull-down arrow at DHCP Server:, a list of options will be displayed. If you want to disable
your DHCP server, select Off from the DHCP Server pull-down arrow (see the screen below). The next screen will
be displayed immediately.
If you selected Off at DHCP Server:, the following screen will be displayed immediately. Click on save to save the
DHCP Server setting. Click on save.