Toshiba GL-1010 - Manual (Page 108)

108
GL-1010 Scan Operator’s Guide
Job Overflow.
Finish ADF
scan. The amount of data has reached the
maximum for one scanning. Reduce the
amount of data to scan again using any of
the following methods:
1. Reduce the number of pages.
2. Reduce the resolution.
3. Select Text/Photo or Text mode.
When this error occurred during continuous
scanning, data of the job completed before
the error occurred was stored.
To use the stored data, press the Finish key.
Scanner
Memory full.
Job is
canceled Scanner memory is full and your request has
not been accepted. Confirm the job in
process on TopAccess. When any job is
present, wait for the job to be completed, or
delete it. When the job is not completed,
delete it. If the error persists, restart the
controller. If the error still persists after
restarting the controller, contact the Network
Administrator.
Message Action (Administrator)
N/A When you press the LIST button on the
Group Select screen, it may take a
abnormally long time to list all addresses.
(When too many addresses are registered.)
The time may have exceeded the AutoClear
copier setting time. You cannot see the list of
addresses.
Set the AutoClear time to a longer period of
time. Use TopAccess (Administrator Mode)
([Administration] - [Device] - [Copier] to
modify the auto timeout setting.
Error Messages Defined
Message Action (End User)
GL-1010 Scan Operator's Guide.book Page 108 Friday, October 5, 2001 10:30 AM