Tandberg Data Autoloader Tandberg LTO2 - Manual (Page 81)

- 65 -
CMer Error Code 2
Table-D2 sorts the contents of CMer error code 2 errors.
Displayed here is a further classification of the operation of CMer error code 1.
Table-D2 CMer Error Code 2 Table
Description
00 This error code is conforms to the upper "CMer Error Code 1".
20
An error occurring during ejection of the cartridge from the drive.
30 An error occurring during loading of the cartridge to the drive.
40 An error occurring during transporter P drive system initialization-error restoration.
50 An error occurring during ejection of the cartridge from the magazine slot.
60 An error occurring during loading of the cartridge to the magazine slot.
70 An error occurring during transporter Y move.
80 An error occurring during inventory check of the cartridges.
81 An error occurring during reading the bar code label.
9X An error occurring during accessing the drive.
CMer Error Code 3
These error codes show an essential factor of CMer error.See Capter6(code with cause
and
Recovery Procedure) .
D.err
The displayed error codes are 4 digits and configured as described below.
Examples of error code displays : D.err
Table-D4 sorts the D.err error codes and their contents.
Table-D4 D.err Error Code Table
Description
The Autoloader detected timeout error on the communication with the drive.
The Autoloader detected parity error on the communication with the drive.
The Autoloader detected framing error on the communication with the drive.
The Autoloader detected overrun error on the communication with the drive.
The Autoloader detected an error on the Load/Unload command.
The Autoloader detected an error on the communication with the drive.
The Autoloader detected an error on the communication with the drive.(NAK retry over)
The Autoloader detected an error on the communication with the drive.(SNAK retry over)
The Autoloader detected cartridge position or timeout error before issuing
Load/Unload/Unthread command.
The Autoloader detected timeout error before issuing Unload command.
The Autoloader detected timeout error before finishing Unload command.
The Autoloader detected state error on the communication with the drive .