Tandberg Data Autoloader Tandberg LTO2 - Manual (Page 74)

- 58 -
Error code Cause Recovery Procedure
The Autoloader detected internal
hardware error. Replace the Autoloader (not including the Drive
Sled Assembly).
The Autoloader detected an error during
the P move system initialization.
Remove the cartridge from the transporter.
Switch off the power of the Autoloader and then
switch the power back on.
The Autoloader detected an error during
the P move system initialization.
Check whether there is any foreign matter in the
transporter.
Switch off the power of the Autoloader and then
switch the power back on.
An error that occurred during the
operation of the bar code reader. Switch off the power of the Autoloader and then
switch the power back on.
The Autoloader detected an error during
error restoration.
Execute cleaning of the Roller.See”Section 5.1.2”
If the phenomenon has a relapse,contact your
nearest Customer Support Center.
The Autoloader detected timeout error
on the communication with the drive.
The Autoloader detected parity error on
the communication with the drive.
The Autoloader detected framing error
on the communication with the drive.
The Autoloader detected overrun error
on the communication with the drive.
The Autoloader detected a error on the
Load/Unload command.
The Autoloader detected a error on the
communication with the drive.
The Autoloader detected a error on the
communication with the drive.(NAK
retry over)
The Autoloader detected a error on the
communication with the drive.(SNAK
retry over)
The Autoloader detected cartridge
position or timeout error before issuinig
Load/Unload/Unthread command.
The Autoloader detected timeout error
before issuing Unload command.
The Autoloader detected timeout error
before finishing Unload command.
The Autoloader detected state error on
the communication with the drive .
Switch off the power of the Autoloader and then
switch the power back on.
If the phenomenon has a relapse,contact your
nearest Customer Support Center.