Tandberg Data Autoloader Tandberg LTO2 - Manual (Page 49)

- 33 -
4.2 Write-Protect Switch
Each LTO data cartridge has a write-protect switch that can be used to prevent accidental
erasure of data. Before inserting the data cartridge into the tape drive, position the write-protect
switch on the front of the cartridge. The position of the write-protect switch is shown below.
Move the write-protect switch to the left to disable write protection.
This means that data can be written to the data cartridge unless software write-protect
is in effect..
Move the write-protect switch to the right to enable write protection.
This means that data can not be written to the data cartridge.
Figure 4-2 Setting the Write-protect Switch
Write-Protect Switch
Write Enable Write Protect