Tandberg Data Autoloader Tandberg LTO2 - Manual (Page 39)

- 23 -
Operation Examples
The operation procedure and LCD indications are described below when loading the cartridge
housed in slot 7 into the drive.
Operation 1 Switch ON the power and wait for the completion of the power-on test.
Display: "READY" and "DRV empty" are alternately displayed.
Operation 2 Press the ENTER key.
Display: STATUS
Operation 3 Press the arrow key and select the "LOAD" command.
Display: LOAD
Operation 4 Press the ENTER key and define the command.
Display: Load Drv?
Operation 5 Press the ENTER key and define the command.
Display: Frm Slt 1?
Operation 6 Press the arrow key and select "Slt 7".
Display: Frm Slt 7?
Operation 7 Press the ENTER key and execute the command.
Display: Complete (when the command ends normally.)
Err. xxxxxx (when an error occurs. xxxxxx is the error code.)