Tandberg Data Autoloader Tandberg LTO2 - Manual (Page 56)

- 40 -
Operation 7 Press the ENTER key and define the command.
Display (line 2): Enable ( or Disable) and
RtyCnt XX are alternately displayed.
5.1.2.2 Setting the CLNROL- function Disable
If you would like to set the CLNROL- function disable, follow the procedure described below.
Important
In normal operation, please use the default settings.
Operation 1 Switch ON the power and wait for the completion of power-on test.
Display: READY and DRV empty are alternately displayed.
Operation 2 Press the ENTER key.
Display: STATUS
Operation 3 Press the arrow key and select the MAINTENANC command
Display : MAINTENANC
Operation 4 Press the ENTER key and define the command.
Display (line 1): PASSWORD
Display (line 2): 0000000000
Tip
If you press the allow key, the number is up or down. If you press the enter
key, the number is decided and the cursor move to the next digit. If you have made a
mistake, press the escape key. All number you have entered are canceled.
Operation 5 In this condition, press the ENTER key and set the above password.
Display (line 2): RCLN MODE?
Operation 6 Press the ENTER key and define the command.
Display (line 2): View?