Toshiba TLP780U - Manual (Page 33)

33
Operations
K EY ST
O N E
AU TO
SE T
EXIT
ON / STANDBY
VOL / ADJ
ENT ER
M EN U
IN P U T
FAN TEMP LAMP ON
2
1
(Green)
(Green) (Green) (Off)
(Off) (Off)
flushing (Orange) (Orange)
A
A
B
C
B C
ON/STANDBY
ON/STANDBY
ON/STANDBY
ON/STANDBY
2
1,2
1,2
MENU
ON/STANDBY INPUT
L-CLICK R-CLICK
ENTER
KEYSTONE AUTO SET
EXIT
PIP FREEZE
MUTE CALL RESIZE
VOLUME/ADJUST
LASER
ON
LAMP
FAN
ON
LAMP
FAN
ON
LAMP
FAN
Turning the power off
Press ON/STANDBY after using the projector.
An instruction message for turning the power off appears on
the screen and disappears after a while. When the
message disappears, operation becomes invalid.
Press ON/STANDBY again.
Cooling starts. Once cooling is completed, the LAMP and
FAN indicators turn off and the standby mode is set. (The ON
indicator turns in orange.)
To protect the light source lamp, the LAMP indicator blinks as long as a mini-
mum of cooling is necessary. The power cannot be turned back on during this
time. Unplugging the power cord at this time will shorten the lamp's duration life.
The cooling fan continues to run for a while to expel the heat remaining inside.
If you are in a hurry, however, you may unplug the power cord at this time.
The standby mode is set.
• The projector consumes about 20W of power in the standby mode. We recommend you to
unplug the power cord when not using the projector for long periods of time.
• Be sure that the LAMP indicator has turned off before unplugging the power cord. Cutting
the power by unplugging the power cord while the projector is operating or the light
source lamp is being cooled will shorten the lamp's duration life. Should a fault or some
other irregularity arise with this unit, unplug the power cord.
• When reinserting the power plug before the lamp has cooled, please wait until the lamp has
cooled sufficiently before use. When the lamp is at a high temperature, it may not light and
the duration life will be shortened.
Remote control
Control panel
(Main unit side)
Indicators
Notes
CONTENTS