Toshiba TEC CB-426-T3-QQ - Manual (Page 95)

Appendix A4 Message and LED
87
Notes:
•
If a command error is found in the command received, 16 bytes of the command error, starting from the
command code, will be displayed. (However, [LF] and [NUL] will not be displayed.)
Example 1
[ESC] T20 E60 [LF] [NUL]
Command error
The following message appears.
Example 2
[ESC] XR; 0200, 0300, 0450, 1200,1 [LF] [NUL]
Command error
The following message appears.
•
When the error command is shown, “? (3FH)” appears for codes other than codes 20H to 7FH and A0H to
DFH.
Display of error message
(See Notes.)
POWER ONLINE ERROR
Printer Status LCD Messages
LED Indication
An error has occurred while writing
to flash memory
An erase error has occurred in
formatting the flash memory.
Data cannot be stored because the
flash memory is full.
The ribbon has run out.
There is a problem with the print
head.
The Stacker is full.
Printing was attempted with the
Stacker turned OFF.
A command error has occurred in
analyzing the command.
No.
NO YES
NO YES
NO YES
YES YES
YES YES
YES YES
YES YES
YES YES
17
18
19
20
21
22
23
24
Restoration
by RESTART
key Yes/No
Acceptance of
Status Request
Reset Command
Yes/No
HEAD ERROR *
STACK OVERFLOW
STACKER ERROR
T20E60
XR;0200,0300,045
FLASH CARD FULL
NO RIBBON ####*
FLASH WRITE ERR.
`
FORMAT ERROR