Toshiba TEC CB-426-T3-QQ - Manual (Page 24)

Chapter 2 Printer Installation
16
21 Close the Top Cover gently. Make sure that the POWER LED
and ON LINE LED are illuminated, and that the “ON LINE”
message is shown. Press the FEED key on the Operation Panel
to feed the media about 1 inch (20 to 30cm). Check that the media
is fed successfully.
Note:
When loading labels, make a straight
cut in the gap area between labels.
Right Wrong
Label
Cut here.
Label
This section contains more information concerning the care that should
be taken when loading the media.
•
The figure below indicates the direction the Supply Roll Holder
(inside) can be moved with the claws of the Supply Roll Holder
locked into the notches.
2.5.1 Additional
Information
Right
Wrong
•
The figure below indicates the direction the Supply Roll Holder
(outside) can be moved with the claws of the Supply Roll Holder
locked into the notches.
Right
Wrong
Notches
Supply Roll Holder
(Inside)
Supply Roll Holder
(Outside)
Notches
2.5 Loading the
Media (Cont.)