Toshiba TEC CB-426-T3-QQ - Manual (Page 30)

Chapter 2 Printer Installation
22
4 Insert the Ribbon Shaft into the Ribbon Winding Core. Fit the
protrusion of the Ribbon Shaft into the notch of the Ribbon
Winding Core. Insert the other Ribbon Shaft into the Ribbon Feed
Core in the same manner.
Protrusion
Notch
Ribbon Winding Core
Ribbon Shaft
Ribbon Feed Core
5 Attach the Ribbon Stoppers gently to each Ribbon Shaft.
CAUTION!
Push in the Ribbon Stoppers
gently. Otherwise, damage
may occur.
Ribbon Feed Core
Ribbon Shaft
Ribbon Stoppers
Ribbon Shaft
6 Unroll about 1 inch (30cm) of the ribbon. Place the Ribbon Module
on the ribbon.
Ribbon Module
Ribbon Winding Core
Ribbon
Ribbon Feed Core
CAUTION!
Loading the ribbon upside
down may cause damage to
the print head, as well as print
failure.
7 Insert the Ribbon Feed Core, and then the Ribbon Winding Core
on the Ribbon Module, as illustrated below.
Ribbon Winding Core
Ribbon Feed Core
Note:
Please make sure that the Ribbon
Stoppers are completely inserted into
the Ribbon Winding Core and Ribbon
Feed Core respectively.
Ribbon Winding Core
2.7.2 Loading
Procedure (Cont.)