Toshiba TEC CB-426-T3-QQ - Manual (Page 106)

Appendix 5 System Mode
98
Note:
When C or D is selected, the acceptable
values are 01 to 29.
Next enter the value within a range of 00 to 31 for the best
alignment.
When entering the value, press the PAUSE key.
When the alignments are complete, the message returns to “<2>
PARAMETER SET”.
Now verify that the X/Y direction alignment is correct.
Press the PAUSE key twice.
Press the PAUSE key. The printer prints the X/Y Direction
Alignment Test.
After printing completes, the message returns to “<2>
PARAMETER SET”.
Selecting the Printer Parameters
Press the PAUSE key.
After “HEAD ADJUST” appears, press the FEED key.
The printer parameters are ready to be selected. Press the PAUSE
key.
Specifying the Character Code
Select the character codes: PC-850 or PC-8.
After selecting the code, press the PAUSE key.
Specifying Zero Font
Select whether a 0 (zero) with a slash or no slash will be used.
After selecting the zero font, press the PAUSE key.
HEAD2 B0_ 0
HEAD ADJUST
CHECK
HEAD ADJUST
PRINTER PARA
Note:
Use the FEED or RESTART key
to select a desired value or option.
FONT CODE PC-850
ZERO FONT 0
A5.4 Parameter
Setting (Cont.)