Troubleshooting, 1 error messages – Toshiba TEC CB-426-T3-QQ User Manual
Page 77
Chapter 6 Troubleshooting
69
Error Messages
This chapter lists the error messages or possible problems and their solutions.
Important!
If a problem cannot be solved by taking actions described in this chapter, do not attempt to
repair the printer. Turn off and unplug the printer. Then contact an authorized service representative
for assistance.
Notes:
•
If an error is not cleared by pressing the RESTART key, turn the printer off and then on.
•
After the printer is turned off, all print data in the printer is cleared.
•
“####” indicates remaining label count up to 9999 (in pieces).
•
“*” indicates which color print head has a problem, as follows:
1: Head 1 (Back)
2: Head 2 (Front)
Solutions
Close the print head block. Then press
the RESTART key.
Close the print head block. Then press
the RESTART key.
Make sure the interface cable is firmly
connected to the computer, and the
computer is turned on.
1 Remove the jammed media, and clean
the Platen, Feed Roller and Pinch
Roller. Then reload the media properly.
Finally press the RESTART key.
2 Turn the printer off and then on. Then
select the media sensor supporting the
media that is loaded. Finally resend
the print job.
3 Adjust the sensor position. Then press
the RESTART key.
4 Turn the printer off and then on. Replace
the loaded media to match the
programmed size, or select a programmed
size that matches the loaded media.
Finally resend the print job.
5 Adjust sensitivity of the media sensor.
If this does not solve the problem, turn
off the printer, and call an authorized
service representative.
HEAD OPEN *
Problems/Causes
The print head block was
opened in Online Mode.
Feed or printing has been
attempted with the print head
block open.
A communication error has
occurred.
1 The media is jammed at the
media path. The media is
not fed smoothly.
2 A wrong media sensor is
selected for the media that is
loaded.
3 The Black Mark Sensor is
not aligned to the black mark
on the media.
4 Size of the loaded media is
not consistent with the
programmed size.
5 The Feed Gap Sensor cannot
distinguish the print area
from a label gap.
HEAD OPEN ####*
COMMS ERROR
PAPER JAM ####