Appendix 5 system mode 108 – Toshiba TEC CB-426-T3-QQ User Manual
Page 116
Appendix 5 System Mode
108
A
B
A
A
A
A
A
A
B
B
B
B
B
B
•
Usually “AUTO” should be selected. Depending on print patterns, the colors may not be aligned, and the
pulse motor speed fine adjustment should be made.
•
The pulse motor speed adjustment allows more precise color registration. However, if the pulse motor
speed needs changing, please contact an authorized service representative.
The X-coordinate fine adjustment is made to adjust the X-coordinate of the drawing horizontally. The X-
coordinate fine adjustment should be made in the effective print range. (If a field reaches the coordinate less
than “0” after the fine adjustment is made in the negative direction, it is adjusted in the negative direction.)
Magnified Views of Slant Line Pattern
•
1-Dot Slant Line (Black Area Ratio: 16.7%)
•
3-Dot Slant Line (Black Area Ratio: 16.7%)
1 In an idle state.
2 Completes printing Label (A), and starts printing Label (B).
3 Printing Label (B).
4 Completes printing Label (B).
5 Cuts the Label (A).
6 Feeds Label (B) to the Cut Position, and cut it off.
7 Feeds the label to the Home Position.