Toshiba TEC CB-426-T3-QQ - Manual (Page 115)

Appendix 5 System Mode
107
A5.7.2 Maintenance Counter/Parameter Check Print Sample and Descriptions
1 Maintenance Counter
•
Total label distance covered (cannot be cleared)
•
Label distance covered
•
Print distance (HEAD 1 and HEAD 2)
•
Cut count
•
Head-up/down count (HEAD 1 and HEAD 2)
•
Ribbon motor drive time (HEAD 1 and HEAD 2)
•
RS-232C hardware error count
•
Momentary power interruption count
2 Parameters
•
Print start position fine adjustment value
•
Cut position fine adjustment value
•
Back feed fine adjustment value
•
Stop position fine adjustment value
•
X direction fine adjustment value (for adjustment before shipment from the factory)
(HEAD 1 and HEAD 2)
•
Y direction fine adjustment value (for adjustment before shipment from the factory)
(HEAD 1 and HEAD 2)
•
Print density fine adjustment value (Thermal transfer)
(HEAD 1 and HEAD 2)
•
X-coordinate fine adjustment value
•
Character code type
•
Font “0”
•
Control code type