Toshiba TEC CB-426-T3-QQ - Manual (Page 105)

Appendix 5 System Mode
97
HEAD ADJUST
Adjusting the Alignment in the X Direction (HEAD 2)
Press the PAUSE key. “HEAD ADJUST” appears. Then press
the PAUSE key again.
The X direction alignment is ready for adjustment. Press the
PAUSE key.
Press the PAUSE key twice.
Align the color for Head 2 in the X direction. Select one of the
following letters for the best alignment: E, F, G or H.
When selecting the letter, press the PAUSE key.
Next enter the value within a range of 00 to 31 for the best
alignment.
After selecting the value, press the PAUSE key.
When the alignments are complete, the message returns to “<2>
PARAMETER SET”.
Adjusting the Alignment in the Y Direction (HEAD 2)
Press the PAUSE key. “HEAD ADJUST” appears. Then press
the PAUSE key again.
The Y direction alignment is ready for adjustment. Press the
PAUSE key.
Press the PAUSE key twice
To align magenta in the Y direction. Select one of the following
letters for the best alignment: A, B, C or D.
After selecting the letter, press the PAUSE key.
Notes:
•
Use the FEED or RESTART key
to select a desired value or option.
•
Use the color for Head 1 as the
reference color.
Note:
When G or H is selected, the acceptable
values are 01 to 29.
HEAD ADJUST
X DIRECTION
HEAD1 _ F00
HEAD2 F0_ 0
Notes:
•
Use the FEED or RESTART key
to select a desired value or option.
•
Use the color for Head 1 as the
reference color. Y DIRECTION
HEAD1 _ B00
HEAD2 _ F00
HEAD2 _ B05
A5.4 Parameter
Setting (Cont.)