Teledyne Refrigerated Sampler 6712FR - Manual (Page 5)

6712FR Refrigerated Sampler
Safety
iii
6712FR Refrigerated Sampler
Safety
The 6712FR Refrigerated Sampler is a “definite purpose” device,
intended for use only with compatible Isco equipment. Do not
use this product with any other manufacturers’ equipment, or for
any other purpose. Use for any purpose not described in this
manual could cause personal injury or property damage.
Electrical Requirements The refrigerator is available in both 120 V and 230 V config-
urations. The required operating voltage for the refrigerator is
listed on the Identification and Serial Number label, placed on
the inside of the sample compartment door.
Refrigerators configured for 120 V operation are equipped with
a North American NEMA 5-15P plug and is intended for use
only with 120 V
, 60 Hz. The power source should be rated for
20 ampere service.
Refrigerators configured for 230 V operation are equipped with
a Continental European CEE 7/7 plug and is intended for use only
with 230 V
, 50/60 Hz. The power source should be rated for 16
ampere service.
Refrigerators in either configuration provide 12.5 V at 5
amperes for the sampler controller. This output is from the
two-pin military-type connector on the cord on top of the refriger-
ator. This output is intended for 6700 Series Sampler controllers
only.
The refrigerator must be installed near a suitable
power outlet. Never use an extension cord.
The power outlet must be visible and easily accessible.
Unplugging the refrigerator is the only means of discon-
necting power.
To minimize the risk of electrical shock, the refrigera-
tor must be connected to an outlet with an electrical
ground contact.
The power source must be a dedicated circuit. The line
must not power any other devices.
Never operate the refrigerator with the lower front or
rear panels removed.
Never operate the refrigerator in an explosive atmo-
sphere.
Do not locate the refrigerator where the lower compart-
ment could become submerged.
Do not lift or carry the refrigerator. Use an appliance
carrying device.
Fuses must be replaced with the required size, current,
voltage, and blow-time specifications. Refer to the
Replacement Parts List for the correct part number.