beautypg.com

Manufacturer’s declaration of conformity – Quatech AirborneDirect WLNG-ET Series User Manual

Page 66

background image

FCC Compliance


Page 60

AirborneDirect™ Ethernet Bridge User's Guide

100-8007-141G

Quatech, Inc. Confidential

MANUFACTURER’S DECLARATION OF CONFORMITY

Trade Name:

AirborneDirect™

Serial Bridge

AirborneDirect™

Ethernet Bridge

Airborne Embedded

Radio Module

Model Number:

ABDB-SE-DP101

ABDB-ET-DP101

WLRG-RA-DP101

Compliance Test
Report Number:

B31211D3 F4AWLNG1

Compliance Test
Report Date:

December 11, 2003

July 17, 2006

Responsible Party
(in USA):

Quatech, Inc.

Address:

5675 Hudson Industrial Parkway

Hudson, Ohio 44236 USA

Telephone Number:

(330) 655-9000



This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation.

If the unit does cause harmful interference to radio or television reception, please refer to your
user’s manual for instructions on correcting the problem.

INDUSTRY CANADA NOTICE (APPLICABLE TO USE WITHIN
CANADA)

This device complies with Canadian RSS-210.

To prevent radio interference to the licensed service, this device is intended to be operated
indoors and away from windows to provide maximum shielding. Equipment (or its transmit
antenna) that is installed outdoors is subject to licensing.

The installer of this radio equipment must ensure that the antenna is located or pointed such
that it does not emit RF field in excess of Health Canada limits for the general population;
consult Safety Code 6, obtainable from Health Canada’s web site:

www.hc-sc.gc.ca/rpb

.