Quatech AirborneDirect WLNG-ET Series - Manual (Page 52)

Airborne Control Center
Page 46
AirborneDirect™ Ethernet Bridge User's Guide 100-8007-141G
Quatech, Inc. Confidential
Note:
The firmware must come from Quatech, Inc. as a .bin file and follow the
file name format:
DirectEthernet_ x.x.x.x.bin
Where xxxx is the version number of the firmware. For example:
DirectEthernet_4.2.0.12.bin
TT
Caution:
TT
Do not attempt to load firmware for an 802.11b/g bridge on an 802.11b
bridge or vice-versa.
To update the firmware, the following sequence must be performed:
• Select the Update link on the ACC screen.
• Enter the name of the new firmware version source file. This file must be of type .bin
and have come from Quatech, Inc. If the file is located on your hard drive, click
Browse…
and locate the source directory and file.
• Verify the correct firmware file has been selected (the file name is displayed in the File to
Upload: field). The file’s name structure must be as follows:
ƒ DirectEthernet_x.x.x.x.bin
o
Where x.x.x.x is the version number of the firmware.
• Click the Update button.
• The message shown in
XX
Figure 17
XX
will be displayed. Wait for the upload to complete.
Figure 20. Precautionary Message