Quantum Instruments DLT 7000 - Manual (Page 258)

SCSI Commands
5-154 Quantum DLT 7000 Tape System
REQUEST SENSE Command (03h) (continued)
Table 5–72 Supported ASC / ASCQ in Hex (continued)
Sense Key ASC ASCQ Description
0Bh 48 00 IDE Message Error
COMMAND 49 00 Invalid Message Error
ABORTED 4B 00 Data Phase Error
(cont.) 4E 00 Overlapped Commands Attempted (queue tag is
not unique, CDB sent with abort tag message, or
untagged, or untagged CDBs are outstanding)
83 00 Can not Retry Read/Write Data Transfer (a
READ/WRITE Data Transfer was aborted due to a
bus parity error or unexpected ATN.
0Dh VOLUME OVERFLOW (No Additional Sense Code or Sense Code Qualifier)
0Eh MISCOMPARE (No Additional Sense Code or Sense Code Qualifier)
1 Medium changer specific command.
2 Contact a service representative.
3 Bad firmware image or code download possible.
Filemark, End of Medium (EOM), and Incorrect Length Indicator (ILI) Bits
Filemark (byte 2, bit 7), EOM (byte 2, bit 6), and ILI (byte 2, bit 5) are names
of fields in the SCSI-2 REQUEST SENSE command. Any of these bits may be set
to a 1 even though the Additional Sense Code (ASC) / Additional Sense Code
Qualifier (ASCQ) bits have a value of 0.
For example:
?
Filemark, EOM, ILI bit may be set to 1 with No Sense key (00h) and ASC /
ASCQ = 00 00.
?
Filemark, EOM, ILI bit may be set to 1 with Recovered Error (01h) and ASC
/ ASCQ = 00 00.
Filemark, BOM, ILI bit may be set to 1 with Medium Error (03h) and ASC /
ASCQ = 00 00.