Quantum Instruments DLT 7000 - Manual (Page 217)

SCSI Commands
Quantum DLT 7000 Tape System 5-113
MODE SENSE (6) / (10) Command (1Ah / 5Ah) (continued)
Table 5–54 Disconnect / Reconnect Page - Field Descriptions
Field Name Description
PS Parameters Savable. When 0, the supported parameters cannot be saved
(savable pages are not supported). When set to 1, it indicates that the
page can be saved in nonvolatile memory by the drive.
Additional Page Length This field indicates the number of bytes in the page. Note that this value
does not include bytes 0 and 1. The length is returned on MODE SENSE
and must subsequently be set to the same value when performing
MODE SELECT.
Buffer Full Ratio Not supported.
Buffer Empty Ratio Not supported.
Bus Inactivity Limit Not supported.
Disconnect Time Limit Not supported.
Connect Time Limit Not supported.
Maximum Burst Size The value in this field specifies the maximum amount of data to be
transferred without disconnecting. A value of 0 sets no limit. This value
is given in 512 byte increments. For example, a value of 8 indicates 4K
bytes. Values that are not multiples of 8 are rounded up to the nearest
multiple of 8.
DTDC Data Transfer Disconnect Control. The value in this field specifies the
restriction when a disconnect is permitted.