Omega RD100B - Manual (Page 47)

2-3
Before Using the Recorder
2
Installation Procedure
The recorder should be mounted on a steel panel of thickness 2 mm to 26 mm.
1. Insert the recorder from the front side of the panel.
2. As shown in the figure below, mount the recorder to the panel using the
mounting brackets that come with the package.
• Use two brackets to support the top and bottom or the left and right sides of
the case. (Remove the seal that is covering the holes for the mounting
brackets beforehand.)
• The proper torque for tightening the mounting screws is 0.7 to 0.9 Nm.
• Mount the recorder to the panel according to the procedure below.
• First, attach the two mounting brackets and temporarily fasten the
attachment screws.
• Next, fix the recorder in place by tightening the attachment screws with the
appropriate torque. When the recorder is approximately perpendicular to
the panel as you fasten the screws, press the mounting bracket against the
case so that they are in contact with each other.
Screw temporarily
Panel
Mounting bracket
Attachment screw
Fix in place
Front
Panel
Mounting bracket
Torque driver
(flat blade)
Attachment screw
Case
In contact
with each other
(The figure shows the case when the mounting
brackets are used on the top and bottom of the case.)
CAUTION
Tightening the screws too much can deform the case or damage the bracket.
2.2 Installation