Omega RD100B - Manual (Page 184)

9-27
Operations Related to the Computation Function (/M1 Option)
9
9.16 Setting the Bar Graph Display Mode
This section explains the details of setting the bar graph display mode.
Basic Setting mode cannot be entered when recording is in progress or when
computation is in progress on models with the computation function (/M1 option).
Procedure
Changing the Settings
1. Hold down the MENU key for 3 seconds to enter Setting mode.
2. Hold down the and keys simultaneously for 3 seconds to enter Basic
¥U‘ting mode.
3. Press the key or SHIFT + key to select Math and then press the
key.
4. Press the key or SHIFT + key to select Bar graph and then press the
key.
5. Set each item and press the key.
Use the key or SHIFT + key to select values.
For the procedure on how to enter values or characters, see section 4.2.
If you press the ESC key in the middle of the operation, the settings entered up
to then are cancelled, and the display returns to a higher level menu.
6. When the Setting complete screen appears, do either of the following:
Press the key to set other channels.
If you are done, press the ESC key.
Set the channel range.
The new setting takes effect.
ESC/?
Select the display mode of the bar
graph.
First channel Last channel
0A-0A Channel
Setting complete
Basic=Math
Math=Bar graph
CH=0A-0A
Graph=Normal
Applying the Changes and Returning to Operation Mode
Press the key or SHIFT + key to select End and then press the key. Press
the key to select Store and then press the key. The changes are applied, and
the screen returns to Operation mode. If you select Abort and press the key, the
changes are discarded, and the screen returns to Operation mode. Press the ESC key
to return to the Basic= screen.
Explanation
Graph
Normal: Sets the base point of the bar graph to the left or right of the recording span
whichever is smaller in value.
Center: Sets the base point of the bar graph to the 50% position of the recording span.