Omega RD100B - Manual (Page 4)

ii
Recorder’s Version and Functions Described in This
Manual
The contents of this manual corresponds to the recorder with version 1.11.
RD100B Versions and Functions
Reference
–
Section 7.19
Section 3.4
Section 5.2
Sections 5.5
and 6.13
Communication
manual
Communication
manual
Suffix Code
–
–
–
–
–
/C3
/C7
Version
1.02 or earlier
1.11
Added or Modified Functions
–
(Added) The printout/display format of the date can be changed.
(Added) Key operation to move the printer carriage near the center
position so that the ribbon cassette can be replaced with
the power turned ON (dot model)
(Changed) Selectable range of alarm values during linear scaling
(including 1-5V and SQRT) is –5% to 105% of the scale
span.
(Changed) Specify the date/time for switching DST and standard time
by the month, the nth day of the week of that month, and
time.
(Added) Modbus slave protocol
Two-wire system
(Changed) Users with the same user name cannot be registered.
• Checking the Version Number
You can check the version number on the System display.
The System display cannot be shown at the factory default condition.
First, register the System display to the display screen.
•
Procedure of registering the System display to the display screen: See section 8.2.
• Procedure of displaying the System display: The screen switches each time the DISP key is pressed. Press the DISP
key repeatedly until System display is shown. The displayed contents on the System display switches every 3
seconds. Check the number shown by the “Version:” item.
Software (Sold Separately)
The RD100B Configuration Software cannot set the new functions (indicated above) available on RD100B
version 1.11. The new functions are planned to be supported on the configuration software to be released after
November 2005.