3 sfp information – Omnitron Systems Technology iConverter 10/100M User Manual
Page 30

4.3.3
SFP Information
The 10/100M module installed with an SFP will provide general and specific information on the SFP. This
information is best viewed with SNMP management software. The following is the information available:
4.3.3.1
SFP A0 Information Display
This section displays fixed SFP Module information for the following areas.
•
Identifier Values
•
Extended Identifier
•
Connector Values
•
Transceiver Codes
•
Encoding Rules
•
Normal Bit Rate
•
Link Length
•
Vendor Name
•
Vendor OUI
•
Vendor Revision Number
•
Laser Wavelength
•
Options
•
Vendor Serial Number
•
Date Code
•
Diagnostic Monitoring Type
•
Enhanced Options
•
SFF-8472 Compliance
4.3.3.2
SFP A2 Information Display
This section displays decoded SFP data collected for the following statistics.
•
Measured Temperature
•
Measured Vcc
•
Measured Bias
•
Measured Tx Power
•
Measured Rx Power
•
Temperature High Alarm Setting
•
Temperature Low Alarm Setting
•
Temperature High Warning Setting
•
Temperature Low Warning Setting
•
Vcc High Alarm Setting
•
Vcc Low Alarm Setting
•
Vcc High Warning Setting
•
Vcc Low Warning Setting
•
Bias High Alarm Setting
•
Bias Low Alarm Setting
•
Bias High Warning Setting
•
Bias Low Warning Setting
•
Tx Power High Alarm Setting
•
Tx Power Low Alarm Setting
•
Tx Power High Warning Setting
•
Tx Power Low Warning Setting
•
Rx Power High Alarm Setting
•
Rx Power Low Alarm Setting
•
Rx Power High Warning Setting
•
Rx Power Low Warning Setting
Page 30