RCA CC638/639 - Manual (Page 57)

55
Recording
1. Make sure camcorder is turned off, and
remove any power supply attached to
the camcorder.
2. Press release tab of clock cell compart-
ment cover and open the compartment.
3. Insert the clock cell with the “+”
terminal facing out.
4. Close the compartment cover. It will
click into place.
Date/Time Display — Install the Clock Lithium Cell
To remove battery
To remove battery, insert a pointed non-
metallic object between battery and
compartment and lift.
The clock cell indicator will flash for a few seconds in the viewfinder when you
turn on the camcorder if the cell has not been installed or needs to be replaced.
Cautions: Lithium cell battery. Replace only with 3-volt lithium cell – such as
CR2025. Use of other cell presents a risk of fire or explosion. Must be disposed of
properly. Never handle punctured or leaking cell. May cause burns or personal
injury.
Keep out of the hands of children. Can cause death or injury if swallowed. If
swallowed, consult a physician immediately for emergency treatment.
The lithium cell used in this device may explode resulting in a fire or chemical burn if
mistreated. Do not recharge, disassemble, heat above 212˚F (100˚C), or incinerate.
Never use metallic tweezers to hold the cell, and never short circuit the + and – sides
of the cell.
BATT. RELEASE
B C
AUDIO
RF
DC OUT
VIDEO
LE N S C O V E R + –
CAMERA
VCR
POWER
OFF
Clock Cell
Compartment
Clock Cell
(+ Side Facing Out)
Insert object here to remove cell.