Model cc638 only: remote control, Model cc638 only: install lithium cell, Remote sensor – RCA CC638/639 User Manual
Page 24
22
Model CC638 Only: Remote Control
Model CC638 Only: Install Lithium Cell
The remote’s lithium cell is packed separately. Install it as follows:
1. Turn remote over, insert a pencil or
paper clip in small hole and remove
battery holder.
2. Insert battery in battery holder so
positive (+) terminal faces up.
3. Replace battery holder in remote until
it clicks into place.
Back of
Remote Control
Holder
Insert Pencil Here
Lithium Cell
The remote operates the camcorder by infrared light, so it is protected from electrical
and sound interference. However, the remote must be aimed directly at the
camcorder’s remote sensor. There cannot be any obstructions between them.
MENU
16X9
BACKLIGHT
AUTO
MANUAL
FRONTLIGHT
AE MODES
EIS
FADE
WIPE
DATE/
TIME
PHOTO
EFFECTS
P
U
S
H
FOC
US
ZOOM
START/STOP
SELF
INT.
TIME
TIME LAPSE
REC
TIME
ANIM.
PAUSE
FF
A.DUB
INSERT
REW
STOP
PLAY
Remote Control Sensor
Notes: Never place anything heavy on top of
the remote control or lay it upside-down.
Replace battery when camcorder fails to
respond to remote.
Remove battery from remote if it will not be
used for a month or more. This will prevent
possible damage from battery leakage.
If leakage occurs, wipe up liquid inside
compartment and replace battery.
Note: The camcorder may not respond to the remote if its sensor is exposed to direct
sunlight or strong artificial light.
Remote Sensor
Cautions: Lithium cell battery. Replace only with 3-volt lithium cell – such as CR2025. Use of
other cell presents a risk of fire or explosion. Must be disposed of properly. Never handle
punctured or leaking cell. May cause burns or personal injury.
Keep out of the hands of children. Can cause death or injury if swallowed. If swallowed, consult
a physician immediately for emergency treatment.
The lithium cell used in this device may explode resulting in a fire or chemical burn if mistreated.
Do not recharge, disassemble, heat above 212˚F (100˚C), or incinerate.
Never use metallic tweezers to hold the cell, and never short circuit the + and – sides of the cell.