Roland VR-700 - Manual (Page 28)

30
Playing the VR-700
3. Assigning an ensemble sound to the lower part
To assign the ensemble sound to the Lower part, press the [TO
LOWER/PEDAL] button.
The [TO LOWER/PEDAL] button will light and “Lo” will be shown in
the display.
At the same time, Split (p. 34) will turn on, allowing you to play the
upper organ sound in the upper part.
fig.ens-assign04.eps
4. Assigning an ensemble sound to the pedal part
To assign the ensemble sound to the Pedal part, hold down the [TO
LOWER/PEDAL] button while you press the [–] button.
The [TO LOWER/PEDAL] button will light and “Pd” will be shown in
the display.
When you press the [SPLIT], [LOWER], and [UPPER] buttons
simultaneously, the Split function will turn on; the higher range
of the keyboard will play the upper part, and the lower range of
the keyboard will play the pedal part (p. 28).
1. Press the [LAYER] button to turn it on; layering is now
enabled.
fig.layer01.eps
2. While holding down an ensemble sound button, press
the button of another ensemble sound.
• While you hold down the two sound buttons, the display will
indicate the volume balance between the two ensemble sounds (p.
31).
• When you play the upper part, you’ll hear the upper organ and the
two ensemble sounds together.
fig.ens-assign11.eps
Lower organ Upper organ
Ensemble sound
Layering Two Ensemble Sounds
Ensemble sound 1
Ensemble sound 2
Upper organ
VR-700_e.book 30 ページ ２００９年１１月１８日 水曜日 午前９時２４分