Roland VR-700 - Manual (Page 15)

17
Names of Things and What They Do
fig.VR-700Rear.eps
[POWER] switch
Turns the power on/off (p. 19).
* If you need to turn off the power completely, first turn off the
[POWER] switch, then unplug the power cord from the power outlet.
Refer to “Power Supply” (p. 6).
AC IN (AC inlet)
Connect the included power cord here (p. 18).
USB connectors
MIDI connectors
PEDAL connectors
OUTPUT connectors
These are stereo output connectors for the audio signal. The same
signal is output from the XLR connectors (L, R) and from the phone
jacks (L/MONO, R).
PHONES jack
Connect headphones here (p. 21).
Even if headphones are connected, the audio signal will still be
output from the OUTPUT connectors.
Rear Panel
Connector Function
USB MEMORY
connector Connect USB memory (sold separately) here (p.
22).
USB MIDI connector
You can use a USB cable (sold separately) to
connect this to your computer so that MIDI
messages can be transmitted and received (p. 67).
Connector Function
MIDI OUT/V-LINK
connector
You can use a MIDI cable (sold separately) to
connect this to a MIDI sound module or other MIDI
device, and transmit performance data from the
VR-700 to that device (p. 65).
If you connect this to a V-LINK compatible video
device, your performance on the VR-700 can
control the video device (p. 64).
MIDI PEDAL IN
connector You can connect a pedal keyboard here, and
perform using the pedals (p. 20).
MIDI IN connector
You can use a MIDI cable (sold separately) to
connect a MIDI keyboard or other MIDI device
here, and use that MIDI device to play the VR-700
(p. 65).
Connector Function
DAMPER PEDAL
connector
Connect a damper pedal here (p. 20).
Even after you take your fingers off the keyboard,
notes will be sustained as long as you hold down
the pedal.
EXP PEDAL
connector Connect an expression pedal here. You can use
this pedal to adjust the volume (p. 20).
CONTROL PEDAL
connector
Connect an expression pedal or damper pedal
here (p. 20). You can use this pedal to control
various functions of the VR-700 (p. 55).
About the phone jacks
If you connect a cable only to the L/MONO jacks of the phone
jacks, the sound of the left and right channels will be mixed
and output in monaural.
* The stereo signal will be output from the XLR connectors.
* We recommend that you use stereo output. If you use
monaural output, the quality and character of the sound may
be affected, but this does not indicate a malfunction.
VR-700_e.book 17 ページ ２００９年１１月１８日 水曜日 午前９時２４分